ADHESIVES

Click Item # to Order

ABOUT INSTA-CURE GLUES: Insta-Cure & Maxi-Cure are Cyanoacrylates (CA's). They have become the choice adhesives for most hobby and household applications. These high quality CA's when used properly, form bonds that in many cases are stronger then the material that is being adhered. With all CA's the closer the parts fit together, the stronger the bond. Shelf life can be prolonged if the dispenser tip is kept clean and capped tight and the glue is stored in the refrigerator or freezer.

Insta-cure: Has water thin viscosity that wicks deep into joints. Cures in a matter of seconds. Surfaces to be bonded must be tight fitting and held together while you apply CA  around the edges of the seam.

Maxi-Cure: Extra thick CA, excellent for most plastics fiberglass, metals and rubber. Designed to bridge gaps and fill voids, Maxi-Cure can be carved with a knife or razor blade and sanded and feathered to finish.

Insta-Set is a catalyst which acts as an accelerator that allows CA's to cure in thick layers. Insta-Set in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. Insta-Set is formulated to bond without degrading the CA's strength.

Quick-Cure 5 Minute Epoxy cures to a slightly flexible consistency. This lack of brittleness allows it to form a long lasting bond.

Kneadatite Sculptors Epoxy Putty Tape This Kneadatite product is wonderful for sculptors.  You can create and repair sculptures, also due masonry repair, and auto projects (filling dents and rust holes).  Work life 45-60 minutes. (commonly known as "Green Stuff"). * Extremely smooth, non-grainy texture. * Long work life (1 1/2 to 2 hrs.) * Holds fine detail and adheres well to almost any surface. * Place "Green Stuff" in the freezer to stop hardening or under a warm lamp to harden faster.

ABOUT KNEADATITE: Miniature figure sculptors and modelers have used "Green" to fill gaps in cast figures, customize pieces with added parts, and make original models.   Kneadatite's features make it very useful for the casting hobbyist.  To use just knead with your fingers until the colors are blended.

MS105: FASTSTEEL Steel-reinforced epoxy putty. Simply the strongest adhesive we have ever used for attaching figures to bases or Swarovski crystals to castings)

ABOUT FASTSTEEL: Hobbyists that want the perfect bonding material for holding strength and ease of use look no further. With FastSteel you can weld parts together in several minutes as the material molds like clay and hardens like steel. It is perfect for working with pewter and all lead/tin alloys. Just cut off the correct amount required and knead with your fingers until the colors are blended. The 4 oz.,  7" strip (which goes a very long way) is packed in a reusable tube.